This designed to read pressure up to 15,000 psi. The system uses 1502 and 2202 hammer unions with diaphragm protectors, piston isolators, or deboosters to separate mud, cement, and the like from system internal parts.


HOW TO ORDER:


Specify capacity of system and hose length

Specify Box or panel mount

Specify type of sensor

WMG100

This designed to read pressure up to 16,000 psi. The dual movement allows for monitoring large and small pressure changes. The unit is primarily used on service truck used in high pressure cementing and fracturing.


HOW TO ORDER:


Specify capacity of system and hose length

Specify Box or panel mount

Specify type of sensor

WMG101

is integrated into one gauge assembly an Inverted 6” gauge assembly mounted on hex housing with 2” male NPT thread. It is complete with a diaphragm cup, a check valve and damper assembly.


HOW TO ORDER:


Specify capacity  

Specify size of hammer union  


WUMG

This unit is designed to reduce line pressure by a ratio of 4:1, this allows operators at the panel to see only ¼ the actual pressure that is seen at the manifold. Gauges are calibrated at ¼ the line pressure to reflect actual pressures.


HOW TO ORDER:


Specify capacity and union needed

Specify service needed (H2S, Standard, etc.)

WWDB4X

This a 6” fluid filled gauge assembly mounted on a customer specified flange.


HOW TO ORDER:


Specify flange size and pressure capacity

Specify ring groove

Specify capacity of gauge

Specify piston isolator or rubber diaphragm

WFG

Wagner Instrumentation 2000’s Single Pointer (WMG100) Mud Pressure System

MUD PRESSURE SYSTEMS

Wagner Instrumentation 2000’s 4:1 Compound (WMG101) dual pointer Mud Pressure System

Wagner Instrumentation 2000’s Unitized Standpipe gauge (WUMG) Mud pressure system

Wagner Instrumentation 2000’s Flange Mounted Gauge assembly (WFG)

Wagner Instrumentation 2000’s 4:1 Debooster (WWDB4X)